Wrong Baudrate in INO?

[SvenHi]

In the arduino sktech, there is the baud rate config for 115200
in all GUI and Atmel Studio project 57600.

=> Is the Arduino sketch really up to date?
Even if I change the baud rate, I get no matching values in the GUI

[VenkateshBhat]

Hello SvenHi,
The SerialUSB on Arduino Zero is a is an emulated serial port (USB-CDC). The SerialUSB class is a special Serial instance which use the hardware USB the speed will always be 115200.

[SvenHi]

  Thank you for response!   Does this mean, I have to change the Baudrate in the Processing GUI (for USB)?   Original code healthypi_desktop.pde:     port = new Serial(this, selectedPort, 57600);   Or does this setting not matter?   In case this setting does not cause conflict with the 115200 baudrate of CDC, I have to search for other issues on my setup. I have the problem, that the device does work in general with Atmel Studio firmware on Raspberry.   If I replace the flash with Arduino Zero bootloader, download INO via Arduino, and use the PC GUI (Win10,64Bit) then I have in general communication between device and GUI, but no valid data in visualization...   Best regard     Gesendet: Donnerstag, 30. März 2017 um 07:33 Uhr Von: VenkateshBhat <notifications@github.com> An: Protocentral/HealthyPi <HealthyPi@noreply.github.com> Cc: SvenHi <s.hirsch@gmx.net>, Author <author@noreply.github.com> Betreff: Re: [Protocentral/HealthyPi] Wrong Baudrate in INO? (#4) Hello SvenHi, The SerialUSB on Arduino Zero is a is an emulated serial port (USB-CDC). The SerialUSB class is a special Serial instance which use the hardware USB the speed will always be 115200. — You are receiving this because you authored the thread. Reply to this email directly, view it on GitHub, or mute the thread.