Zohd altus problems

[bobsalter]

I have set up the altus in inav as a vtail and added an extra motor manually. When I go to the mixes tab it shows two motors and six servos. Since there are only four servos and the two motors can anyone help explain what is going on. With inav both motors work but with the transmitter they don't despite all being well in receiver tab. All servos act as they should. Thanks in advance

[daijoubu]

Can you post the mixer tab? Likely you don't have throttle being sent to the motor by the mixer.

[bobsalter]

[bobsalter]

This is it. It looks ok in outputs but the throttle is greyed out. Thanks

[daijoubu]

How are the motors wired? S1 and S2 on the board? Motor 1 and 2 look correct in the motor mixer section with a 1 in the throttle column.

Servo 1 is receiving RC throttle commands and putting it on S3. You probably don't want that. Same with servo 2 on S4. What is plugged in there on the board? I would expect those lines to say stabilized roll.